Electrolux ERG1401AOW - Installation

Problem Possible cause Solution
Temperature cannot be
set.
The FastFreeze or Inten‐
sive Cooling function is
switched on.
Switch off FastFreeze or
Intensive Cooling manual‐
ly, or wait until the function
resets automatically to set
the temperature. Refer to
"FastFreeze or Intensive
Cooling function".
The temperature in the ap‐
pliance is too low/too high.
The temperature regulator
is not set correctly.
Set a higher/lower temper‐
ature.
The door is not closed cor‐
rectly.
Refer to "Closing the door".
The food products' temper‐
ature is too high.
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
Many food products are
stored at the same time.
Store less food products at
the same time.
The door has been opened
often.
Open the door only if nec‐
essary.
The Intensive Cooling
function is switched on.
Refer to "Intensive Cooling
function".
There is no cold air circula‐
tion in the appliance.
Make sure that there is
cold air circulation in the
appliance.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
8.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
8.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
9. INSTALLATION
WARNING!
Refer to Safety chapters.
9.1 Location
Refer to the assembly
instructions for the
installation.
ENGLISH 25