8.4 Door reversibility
To carry out the following opera-
tions, we suggest that this be
made with another person that will
keep a firm hold on the doors of
the appliance during the opera-
tions.
To change the opening direction of the
door, do these steps:
• Remove the plug from the power sock-
et.
• Tilt back the appliance carefully so that
the compressor cannot touch the floor.
• Unscrew the left foot.
• Unscrew the screws of the door bottom
hinge.
2
1
• Take off the appliance door by pulling it
slightly downwards.
• Unscrew the top door hinge pin of the
appliance then screw it back on the
other side.
• Fit the appliance door on the upper
door hinge pin.
• Remove the lower hinge. Put over the
pin in the direction of the arrow.
• Unscrew and install the screw on the
opposite side.
• Install the lower hinge on the opposite
side leaving the position of the door un-
changed.
• Screw in the one screw in the place set
free on the other side as well as the
right adjustable foot .
1
2
3
4
• Remove and install the handle (if fore-
seen) on the opposite side.
• Reposition, level the appliance, wait for
at least four hours and then connect it
to the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
ENGLISH 27
To Next Page
Loading...
