Problem Possible solution
The required temperature is
not reached.
The display shows E3.
• Contact an Authorised Service Centre.
The anti-flood device is on and
an intermittent acoustic signal
sounds for approximately 30
seconds.
The display shows E4.
• Close the water tap and contact an Authorised
Service Centre.
Technical malfunction of the
appliance.
The display shows Ed.
• Contact an Authorised Service Centre.
Once you have checked the appliance,
set and start the programme again. If the
problem occurs again, contact an
Authorised Service Centre.
For alarm codes not described in the
table, contact an Authorised Service
Centre.
9.2 The dishwashing and drying results are not satisfactory
Problem Possible cause Possible solution
The dishes are not clean. The selected programme
was not applicable for the
type of load and / or for the
degree of soil.
Make sure that the pro‐
gramme is suitable to the
type of load and / or for the
degree of soil.
The basket was not loaded
correctly, water did not
reach all surfaces.
Load the basket correctly.
The spray arm could not
turn freely because of the
incorrect arrangement of
the load.
Make sure that the spray
arm can turn freely before
you start a programme.
The filters are clogged. Make sure that the filters
are clean.
The filters are not correctly
assembled and installed.
Make sure that the filters
are correctly assembled
and installed.
The quantity of detergent
was not enough or no de‐
tergent was used.
Make sure that a correct
amount of detergent is
used.
ENGLISH 15
To Next Page
Loading...
