Problem Possible cause Possible solution
Scale particles on the
dishes.
The salt container is emp‐
ty.
Fill the salt container with
specific salt for dishwash‐
ers.
The cap of the salt contain‐
er is not closed correctly.
Make sure that the salt
container is correctly
closed.
There are streaks or milky
stains on glasses and
dishes.
The level of the water soft‐
ener is too high.
Set the water softener to a
lower level.
There are bluish layers on
glasses and dishes.
The rinse aid dosage is too
high.
Set the rinse aid dispenser
to a lower position.
The detergent can be the
cause.
Try a different brand of de‐
tergent.
The dishes are wet and
dull.
A programme without a
drying phase has been se‐
lected.
Set a programme with a
drying phase.
The rinse aid dispenser is
empty.
Fill the rinse aid dispenser
with rinse aid.
10. INSTALLATION
10.1 Assembly
Make sure to position the
appliance with minimum
space of 50 mm on both
sides of fully open door.
min.
550 mm
min.
443mm
100
80
min.
555mm
• Keep 5 mm distance between both
sides of the appliance and the
cabinet. There are two possibilities for
the cabinet opening for the appliance.
• Power cord, drain hose and water
supply line opening. To facilitate a
proper installation, position the
opening to the right or the left of the
appliance.
10.2 Electrical connection
WARNING!
Do not use an extension
cord or and adapter plug
with this appliance.
WARNING!
Do not cut or remove the
earthing.
WARNING!
Make the electrical
connection with the power
cord.
For rating voltage check the
rating plate.
www.electrolux.com16
To Next Page
Loading...
