follow the procedure from step (1) to
step (2).
2. Press button (4).
• The indicators of buttons (2) and (3)
go off.
• The indicator of button (4) continues
to flash.
• The end indicator comes on.
3.
Press button (4), the end indicator
goes off. The acoustic signal for the
end of programme is deactivated.
4.
Press the on/off button to deactivate
the appliance and to confirm the set-
ting.
6. BEFORE FIRST USE
1.
Make sure that the set level of the wa-
ter softener agrees with the water
hardness in your area. If not, adjust
the water softener. Contact your local
water authority to know the water
hardness in your area.
2. Fill the salt container.
3.
Fill the rinse aid dispenser.
4. Open the water tap.
5.
Processing residues can stay in the
appliance. Start a programme to re-
move them. Do not use detergent and
do not load the baskets.
If you use the combi detergent
tablets, activate the Multitab op-
tion.
6.1 Adjusting the water softener
Water hardness
Water softener
adjustment
German
degrees
(°dH)
French
degrees
(°fH)
mmol/l Clarke
degrees
Manual Elec-
tronic
51 - 70 91 - 125 9.1 - 12.5 64 - 88
2
1)
10
43 - 50 76 - 90 7.6 - 9.0 53 - 63
2
1)
9
37 - 42 65 - 75 6.5 - 7.5 46 - 52
2
1)
8
29 - 36 51 - 64 5.1 - 6.4 36 - 45
2
1)
7
23 - 28 40 - 50 4.0 - 5.0 28 - 35
2
1)
6
19 - 22 33 - 39 3.3 - 3.9 23 - 27
2
1)
5
1)
15 - 18 26 - 32 2.6 - 3.2 18 - 22 1 4
11 - 14 19 - 25 1.9 - 2.5 13 - 17 1 3
4 - 10 7 - 18 0.7 - 1.8 5 - 12 1 2
< 4 < 7 < 0.7 < 5
1
2)
1
2)
1)
Factory position.
2)
Do not use salt at this level.
You must adjust the water soften-
er manually and electronically.
8
www.electrolux.com
To Next Page