10.3 Acoustic signals
The acoustic signals operate when:
• The programme is completed.
• The appliance has a malfunction.
To deactivate/activate the acoustic
signals, press
and at the same
time for 3 seconds.
If you deactivate the
acoustic signals, they
continue operate when the
appliance has a malfunction.
10.4 Operating Hours Counter
It is possible to visualise the total
operating time of the appliance in hours,
starting from the first switching on. This
value will count operating time of the
cycles (does not include pauses, delayed
start time). To visualise this value,
proceed as follows:
1. Switch the appliance on by turning
the programme knob to the Eco
40-60 programme (1st position
clockwise).
2. Press and hold the and
buttons for some seconds (within 10
seconds after the switching on. After
these 10 seconds, the key
combination activates and
deactivates the acoustic signals).
3. After 3 seconds the total hours
operated by the appliance are shown
in the display: e.g. 1276 hours, the
display shows the text Hr for 2
seconds, 12 (thousands and
hundreds) for 2 seconds and 76 (tens
and units).
If the procedure does not
work (due to timeout, wrong
programme dial position or
wrong keys combination),
switch the appliance off and
repeat sequence from the
beginning.
10.5 Factory Reset
This function allows to restore the factory
default options. To activate this option
follow steps below:
1. Switch the appliance on by turning
the programme knob to the
Synthétiques programme (3rd
position clockwise).
2. Press and hold the and
buttons for some seconds (within 10
seconds after the switching on. After
these 10 seconds, the key
combination activates and
deactivates the acoustic signals).
3. The display will show
for
about 5 seconds.
If the procedure does not
work (due to timeout, wrong
programme dial position or
wrong keys combination),
switch the appliance off and
repeat sequence from the
beginning.
11. BEFORE FIRST USE
During installation or before
first use you may observe
some water in the appliance.
This is residual water left in
the appliance after a full
functional test in the factory
to ensure the appliance is
delivered to customers in
perfect working order and is
no cause for concern.
1. Connect the mains plug to the mains
socket.
2. Open the water tap.
3. Put a small quantity of detergent in
the compartment for washing phase.
4. Set and start a programme for cotton
at the highest temperature without
laundry.
This removes all possible dirt from the
drum and the tub.
ENGLISH 19
To Next Page
Loading...
