When the flap is in position B and you want
to use powder detergent:
1. Remove the drawer.
2. Adjust the flap in position A.
3. Put back the drawer in the recess.
12.4 Setting a programme
1. Turn the programme knob and set
the programme:
• The indicator flashes.
• The display shows the level of the
Time Manager, the programme
duration and the indicators of the
phases of the programme.
2. If necessary, change the temperature
and the spin speed or add available
options. When you activate an
option, the indicator of the set option
comes on.
If you set something
incorrect, the display shows
the message .
12.5 Starting a programme
without the delay start
Press .
• The indicator of
stops to flash
and stays on.
• The indicator starts to flash
on the display.
• The programme starts, the door
locks, the display shows the
indicator .
• The drain pump can operate for a
short time when the appliance fills
water.
After approximately 15
minutes from the start of the
programme:
• The appliance adjusts
automatically the
programme duration
agree with the laundry
load.
• The display shows the
new value.
12.6 Starting a programme with
the delay start
1. Press Départ Différé again and again
until the display shows the delay you
want to set.
The related indicator comes on the
display.
2. Press :
• The appliance starts the
countdown.
• The door locks, the display shows
the indicator .
• When the countdown is
completed, the programme starts
automatically.
You can cancel or change
the set of the delay start
before you press the . To
cancel the delay start:
• Press to set the
appliance to pause.
• Press Départ Différé
until the display
shows '.
• Press
again to
start the programme
immediately.
12.7 The AutoSense System
load detection
The programme duration in
the display is referred to a
medium/high load.
www.electrolux.com22
To Next Page
Loading...
