ENGLISH
11
Operating sequence
Before the first wash we recommend that you pour
2 litres of water into the main wash compartment
ECO valve. Then run the automatic cycle with the
machine empty, in order to remove any
manufacturing residue from the drum and tub.
Pour half a measure of detergent into the main
wash compartment and start up the machine.
1. Place the laundry in the drum
Open the door.
Place the laundry in the drum, one item at a time,
shaking them out as much as possible.
Close the door.
2. Measure out the detergent
Pull out the dispenser drawer until it stops. Measure
out the amount of detergent recommended by the
manufacturer in a graduated cup and pour it into the
main wash compartment .
If you wish to carry out the pre-wash, pour detergent
into the appropriate compartment marked .
3. Measure out the additive
If required, pour fabric softener into the compartment
marked , without exceeding the «MAX» mark.
4. Select the desired programmes
Turn the programme selector dial to the desired
position.
The LED corresponding to the Start / Add clothes
button starts to flash.
5. Select the option “Quick Wash”
if required
The LED corresponding to the Quick Wash button
illuminates
6. Start the machine
Push the Start / Add clothes button and the
programme starts
The LED corresponding to the Start/ Add clothes
button illuminates
To Next Page
Loading...
