Electrolux EWF1070M - Page 22

SERVICE MANUL
EWF1070M
EWF1070W
Washing Machine
２２
Error message :The heater may be broken
Troubleshooting:
Error message:The required water level is not reached within 8 min.
Troubleshooting:
Cut off power ,check the resistance
Of two pins of heater element by
multimenter is it between 30-35Ω ?
Heater element
must be broken
please replace
it
Turn
on power ,and set wash
mode,then start ,check the export
voltage of heater element between
12-6 and J9-9 ,is it between AC
220-240V?
PCB must be
broken, please
replace it
Check if water is leaking from washer
bottom. inlet pipe. drain pipe or other
pipe connection
Y
Readjust or replace the broken parts
N
N
Check if tap is closed or water pressure is too
low (usual between0.03 -1 MPa)
Open the tap or wait for normal water pressure to use
Y
N
Check if inlet valve is jammed
Clean inlet valve
Y
N
Draw out the dispenser and check if water is
entering
Observe if the height of
drain pipe not reach 80
cm. If water level
pressures switch and
the hose is leaking gas
Y
PDF 文件使用 "pdfFactory" 试用版本创建 www.fineprint.cn