14
Run a Washing CycleWashing Cycleycle
Brief Instructions
A washing cycle is run in the following steps:
1. Set the correct washing program:
– Set the program and temperature with the pro-
gram selector
– Set any additional program(s) if required
2. Change the spin speed if necessary / select
RINSE HOLD (Spülstopp, Arrêt Cuvé Pleine).
3. Set DELAY TIMER (Zeitvorwahl, Départ Différé) if
necessary.
4. Open the filling door and fill with washing.
5. Close the filling door.
6. Add washing detergent/care agent.
7. Start the washing program.
After the Washing Program Ends:
Attention! If the washing cycle ended with RINSE
HOLD (Spülstopp, Arrêt Cuvé Pleine), before open-
ing the filling door carry out PUMP OUT (Pumpen,
Vidange), SPIN (Schleudern, Essorage) or SHORT
SPIN (Schonschleudern, Essorage Délicat).
8. Open the filling door and remove the washing.
9. Switch off the washing machine: Set the program
selector to OFF (Aus, Arrêt).
To Next Page
Loading...
