How to fix Electrolux EWF12932 Washer that won't start?
If your Electrolux washer doesn't start, make sure the door is firmly closed, the plug is properly inserted into the power socket, and the Start/Pause button has been pressed. Also, check your domestic electrical installation to ensure there is power at the socket. If a delayed start was selected, cancel it to start the wash immediately.
Why is my Electrolux EWF12932 not filling with water?
If your Electrolux washer isn't filling with water, ensure the water tap is fully open and the inlet hose isn't squashed or kinked. Also, check and clean the water inlet hose filter if it's blocked, and make sure the door is properly closed.
What to do if there is water on the floor near Electrolux Washer?
If there is water on the floor, it could be due to using too much or unsuitable detergent, which creates excessive foam. Try reducing the amount of detergent or switching to a different one. Also, check the water inlet hose connection for any leaks and replace the drain hose if it's damaged.
Why is my Electrolux Washer vibrating or noisy?
If your Electrolux washer vibrates or is noisy, ensure that the transit bolts and packing have been removed and that the support feet have been properly adjusted to level the appliance. Pause the machine and redistribute laundry manually if it's not evenly distributed in the drum. If there is very little laundry in the drum, load more laundry. Reduce the detergent quantity or use another one if there is detergent over dose.
How to open Electrolux Washer door if it won't open?
If the door of your Electrolux washer won't open, wait until the end of the washing cycle or about 5 minutes for the door lock to release. If there is still water in the drum, select the ‘Spin’ program to empty it out.
Why Electrolux EWF12932 Washer is making an unusual noise?
If your Electrolux washer is making an unusual noise, make sure the levelling of the appliance is correct. Make sure that the packaging and/or the transit bolts are removed. Add more laundry in the drum if the load may be too small.
What causes late spinning or no spinning in Electrolux Washer?
If the spinning starts late or the Electrolux washer does not spin, pause the machine and redistribute laundry manually because the electronic unbalance detection device has cut in because the laundry is not evenly distributed in the drum.
What to do if Electrolux EWF12932 Washer fills then empties immediately?
If your Electrolux washer fills and then empties immediately, check the drain hose connection to make sure it is not squashed or kinked. Clean the drain filter if the drain pump is clogged. If the option ‘Rinse Hold’ or ‘No Spin’ has been selected, disable the option and select spin program.
How to improve unsatisfactory washing results in Electrolux EWF12932?
If your Electrolux washer shows unsatisfactory washing results, increase the detergent quantity or use another one if too little or unsuitable detergent has been used. Use commercial products to treat the stubborn stains that have not been treated prior to washing. Check if you have selected the correct temperature. Reduce load if there is excessive laundry load.
General| Load Capacity | 9 kg |
|---|---|
| Energy Rating | A+++ |
| Spin Speed | 1200 rpm |
| Type | Front Load |
| Loading type | Front Loading |
| Noise Level (Spin) | 77 dB |
| Weight | 70 kg |
| Delay Start | Yes |
| Child Lock | Yes |
| Display Type | LED |
| Dimensions (HxWxD) | 850 x 600 x 600 mm |
| Programs | 15 |
To Next Page