Electrolux EWF14922 - Starting a Program

16 www.electrolux.com
Measure out the amount of
detergent required, pour it into
the main wash compartment
( ).
Do not put more liquid than
the maximum level.
-
Do not set the DELAY START.
-
Do not set the PREWASH
phase.
-
Pull out the dispenser drawer
until it stops.
-
-
Measure out the detergent and
the fabric softener;
2.
If you wish to carry out the
“Prewash” phase, pour it into
the compartment marked .
If required, pour fabric softener
into the compartment marked
(the amount used must not
exceed the “MAX” mark in the
drawer).
-
-
Close the drawer gently.
-
ATTENTION !
If you turn the program selector
dial to another program when the
machine is working, the red
Start/Pause pilot light will flash 3
times and the message “ ”
will appear on the display to
indicate a wrong selection. The
machine will not perform the new
selected program.
The appliance will automatically
adjust the selected program
duration according to the type
and size of the load.
-
The display will show adjusted
program duration.
-
Step 4 - Starting a program
To start a program, press the
Start/Pause ( ) touchpad, the
corresponding pilot light will stop
flashing and a default program
duration will be displayed on the
screen.
After approx. 15 minutes
from the start of a program: