9.1 What to do if...
Problem Possible cause Solution
The appliance does not
operate.
The appliance is switch‐
ed off.
Switch on the appliance.
The mains plug is not
connected to the mains
socket correctly.
Connect the mains plug to
the mains socket correctly.
There is no voltage in the
mains socket.
Connect a different electrical
appliance to the mains sock‐
et, to check if electricity is
flowing. If not, contact a
qualified electrician.
The circuit breaker trip‐
ped or a blown fuse.
Turn on the circuit breaker or
change the fuse.
The compressor operates
continually.
Temperature is set incor‐
rectly.
Refer to the "Operation"
chapter.
The room temperature is
too high.
Refer to the "Installation"
chapter.
The door is opened too
often.
Do not keep the door open
longer than necessary.
The door is not closed
correctly.
Refer to the "Closing the
door" section.
The light does not work. The light is turned off. Turn on the light. Refer to
the "Light setup" section.
The appliance is not
plugged in.
Connect the appliance.
The circuit breaker trip‐
ped or a blown fuse.
Turn on the circuit breaker or
change the fuse.
The lamp is defective. Contact the Authorised Serv‐
ice Centre.
The light button is not op‐
erating.
Contact the Authorised Serv‐
ice Centre.
Too much vibration. The appliance is not sup‐
ported properly.
Check if the appliance
stands stable.
The appliance is noisy. The appliance is not sup‐
ported properly.
Check if the appliance
stands stable.
Water flows on the rear
plate of the appliance.
During the automatic de‐
frosting process, frost
melts on the rear plate.
This is correct.
Water flows inside the
wine cabinet.
The appliance drain is
clogged.
Clean the appliance drain
hole. Refer to the "Cleaning
the drain" section.
ENGLISH 15
To Next Page
Loading...
