Problem Possible cause Solution
The compressor operates
continually.
Temperature is set incor‐
rectly.
Refer to the "Operation"
chapter.
The room temperature is
too high.
Refer to the "Installation"
chapter.
The door is opened too
often.
Do not keep the door open
longer than necessary.
The door is not closed
correctly.
Refer to the "Closing the
door" section.
The light does not work. The light is turned off. Turn on the light. Refer to
the "Light setup" section.
The appliance is not
plugged in.
Connect the appliance.
The circuit breaker trip‐
ped or a blown fuse.
Turn on the circuit breaker or
change the fuse.
The lamp is defective. Contact the Authorised Serv‐
ice Centre.
The light button is not op‐
erating.
Contact the Authorised Serv‐
ice Centre.
Too much vibration. The appliance is not sup‐
ported properly.
Check if the appliance
stands stable.
The appliance is noisy. The appliance is not sup‐
ported properly.
Check if the appliance
stands stable.
Water flows on the rear
plate of the appliance.
During the automatic de‐
frosting process, frost
melts on the rear plate.
This is correct.
Water flows inside the
wine cabinet.
The appliance drain is
clogged.
Clean the appliance drain
hole. Refer to the "Cleaning
the drain" section.
Water flows inside the
wine cabinet.
Products prevent that
water flows into the water
collector.
Make sure that products do
not touch the rear plate.
The temperature in the
wine cabinet is too low or
too high.
The temperature regula‐
tor is not set correctly.
Set a higher or lower tem‐
perature.
The door is not closed
correctly.
Refer to the "Closing the
door" section.
If the advice does not lead to
the desired result, call the
nearest Authorised Service
Centre.
9.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
ENGLISH 33
To Next Page
Loading...
