Always unplug the appliance before cleaning.
1
2
Motor Housing. Never immerse the blender base in water! Clean it only with a damp cloth.
Do not use abrasive cleaners, scouring pads or abrasive detergents while cleaning the appliance.
Jar (3), blade assembly (4), lid (2), measuring cup (1), and all parts of takeaway bottle (11-14) are
dishwasher safe.
If washing by hand, don’t use wire brush, steel wool or bleach to avoid rust.
Notes: Always detach the blade assembly with jar for cleaning to ensure no leftover food stuck
in between. Don’t immerse the Blade assembly into water completely.
WARNING! the blades are very sharp. Handle carefully during cleaning.
CLEANING AND CARE ( picture page ‘5’ )
WARNING! During operation, do not remove your jar from blender base. If it’s necessary to
remove the jar, please turn off the appliance first then remove it.
WARNING! With heavy load (maximum capacity), do not let the blender run for more than 2 minutes.
Allow it to cool down for at least 20 minutes before continuing.
Pro Tips: With Pulse mode you can give the ingredients a quick mix to achieve your desired consistency.
The blender will operate until the program is finished. To stop any program manually, turn the knob to
OFF position.
Remove the jar (3) from blender base (5) by turning it counterclockwise and pull it off, then pour
and serve.
Wash the components right after use in order to avoid drying of food residue on components.
Pro Tips: Always detach blade assembly with jar and rinse them clean even before placing it
into the dishwasher. Fill the jar with 1.5L lukewarm water and dishwasher liquid then run
MAX speed for 30 seconds for rinsing purpose.
Using 2-in-1 takeaway bottle.
a. Fill the ingredients in the takeaway bottle (11).
b. Push the central blade (12) to blade holder (13) to create a blade assembly.
WARNING! The blades are very sharp!
c. Fasten the blade assembly on the open end of the bottle by turning it clockwise. Turn the takeaway
bottle upside down.
d. Push down the assembled takeaway bottle onto the blender base (5) and rotate it clockwise to lock
until it clicks into position.
e. Turn the knob to the ”ON” position then select the program accordingly, or Turn the knob over
”ON” position onto the desired speed directly (see no.2 program/speed setting). Once done,
turn the knob to OFF position.
f. Turn the assembled takeaway bottle counterclockwise to release it off from blender base.
g. Take off the blade assembly by turning it counterclockwise.
WARNING! Always take off the blade assembly within 1 minute after blending to avoid hard
disassemble afterwards.
h. Attach the lid (14) to enjoy your blending on-the-go
Unplug the appliance.
8
9
10
11
12
HR
DK
CZ
EN
EE
FI
FR
DE
HU
IT
LV
LT
NO
PL
RO
RU
RS
SK
SI
SE
TR
UA
AR
To Next Page
Loading...
