CCoommppoonneenntt TTeeaarrddoowwnn
4-13
IInntteerrnnaall CCaabbiinneett CCoommppoonneennttss
CCooffffeeee GGrroouunnddss DDrraawweerr
The coffee grounds drawer collects used coffee
grounds from the brewing process. A screw with a
plastic standoff mounted to the back of the coffee
grounds drawer triggers a microswitch to allow brewing
operation. The drip tray drain tube passes through the
coffee grounds drawer and slides into a grommet on
drip tray.
To remove the coffee grounds drawer (See Figure 4-26):
1. Remove drip tray and open door.
2. Open brewing compartment door.
3. Pull coffee grounds drawer out of unit.
BBrreewwiinngg UUnniitt DDoooorr
The brewing unit door is secured with two hinges
mounted to the unit frame and houses the dispenser
assembly and hot water wand assembly. A water line
runs from the boiler to hot water dispenser assembly.
To remove the coffee grounds drawer (See Figure 4-27):
1. Remove drip tray and open door.
2. Remove coffee grounds drawer.
3. Open brewing compartment door.
4. Remove steam and hot water nozzle from hot water
wand assembly by turning nozzle counter clock-
wise.
5. Using a phillips head screwdriver, extract screws
securing hot water wand assembly to the
brewing unit door.
6. Remove water line from hot water wand assembly
by pushing back on the water line fitting while
pulling water line out of water line fitting.
7. Using a phillips head screwdriver, loosen the screw
from each hinge securing brewing door hinge to the
hinge mounts on unit frame. Pull brewing unit door
until keyhole slot clears the head of screw. Remove
brewing door from unit.
NNOOTTEE::
The brewing unit door may also be removed by
extracting the 2.5mm allen head screws that secure the
hinges to brewing unit door.
FFiigguurree 44--2277.. BBrreewwiinngg UUnniitt DDoooorr RReemmoovvaall
FFiigguurree 44--2266.. CCooffffeeee GGrroouunnddss DDrraawweerr RReemmoovvaall
Water Line
Connection
Hinge
Screws
Brewing Door
Screws
Disconnect Here
Drip Tray
Drain Tube
Grab Here
To Next Page
Loading...
