WARNING!
Risk of burns! Refer to safety chapter
in oven user manual.
Clean the filters with damp cloth. Set the
oven for 200°C and keep filters inside for
2 hours. Leave the filters to cool down.
5. To install the filter, perform the steps in
reverse order. The filter has to be fully
dried before installing it back into
appliance.
Replace the filter bed every 2 years or when
the cloth is damaged.
6.4 Replacing the lamp
This appliance is supplied with a LED lamp.
This part can be replaced by a technician
only. In case of any malfunction refer to
"Service" in the "Safety Instructions" chapter.
7. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
7.1 What to do if...
Problem Possible cause Remedy
You cannot activate the appliance. The appliance is not connected to a
power supply or it is connected in‐
correctly.
Check if the appliance is correctly
connected to the electrical supply.
You cannot activate the appliance. The fuse is blown. Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
The lamp does not operate. The lamp is defective. Replace the lamp. Refer to the
"Care and Cleaning" chapter.
The appliance does not absorb
enough vapours.
The motor speed is not adequate to
the appearing vapours.
Change the speed of the motor.
The filter alarm indicator is on.
The filter alarm is on. The grease fil‐
ter must be cleaned or the charcoal
filter must be replaced or cleaned.
Refer to the filter notification in "Dai‐
ly use" chapter.
8.
GUARANTEE
Customer Service Centres
Point of Service
Industriestrasse 10
5506 Mägenwil
Le Trési 6
1028 Préverenges
Via Violino 11
6928 Manno
59
To Next Page
Loading...
