Electrolux KEAF7200L User Manual

German de‐
grees (°dH)
French de‐
grees (°fH)
mmol/l Clarke de‐
grees
Water softener
level
<4 <7 <0.7 < 5
1
2)
1)
Factory setting.
2)
Do not use salt at this level.
Regardless of the type of detergent
used, set the proper water hardness
level to keep the salt refill indicator
active.
Multi-tabs containing salt are
not effective enough to
soften hard water.
Regeneration process
For the correct water softener operation,
the resin of the softener device needs to
be regenerated regularly. This process is
automatic and is the part of the normal
dishwasher operation.
When the prescribed quantity of water
(see values in the table) has been used
since the previous regeneration process,
a new regeneration process will be
initiated between the final rinse and the
programme end.
Water softener
level
Amount of water
(l)
1 250
2 100
3 62
4 47
5 25
6 17
7 10
8 5
9 3
10 3
In case of the high water softener setting,
it may occur also in the middle of the
programme, before the rinse (twice
during a programme). Regeneration
initiation has no impact on the cycle
duration, unless it occurs in the middle of
a programme or at the end of a
programme with a short drying phase. In
that cases, the regeneration prolongs the
total duration of a programme by
additional 5 minutes.
Subsequently, the rinsing of the water
softener that lasts 5 minutes may begin
in the same cycle or at the beginning of
the next programme. This activity
increases the total water consumption of
a programme by additional 4 litres and
the total energy consumption of a
programme by additional 2 Wh. The
rinsing of the softener ends with a
complete drain.
Each performed softener rinse (possible
more than one in the same cycle) may
prolong the programme duration by
another 5 minutes when it occurs at any
point at the beginning or in the middle of
a programme.
All the consumption values
mentioned in this section are
determined in accordance
with the currently applicable
standard in laboratory
conditions with water
hardness 2.5mmol/L
according to the 2019/2022
regulation (water softener:
level 3).
The pressure and the
temperature of water as well
as the variations of the
mains supply can change
the values.
How to set the water softener
level
Make sure the appliance is in user mode.
www.electrolux.com10

Electrolux KEAF7200L Specifications

General

Connected load	1950 W
AC input voltage	220 - 240 V
AC input frequency	50 Hz
Energy efficiency scale	A to G
Water consumption per cycle	9.9 L
Cycle time	227 min
Noise level	49 dB
Drying system	AirDry
AquaStop function	-
Delay start (max)	3 h
Delayed start timer	Yes
Dishwashing programs	90min, 160min 60°C, Eco, Quick 30min 40°C, Rinse
Number of place settings	13 place settings
Number of washing programs	5
Number of temperature settings	3
Feet adjustment	80 mm
Door color	White
Door hinge	Sliding
Water fill	Cold, Hot
Cord length	1.5 m
Control type	Buttons
Product size	Full size (60 cm)
Appliance placement	Fully built-in
Baskets adjustable placement	Upper

Weight and Dimensions

Depth	550 mm
Width	596 mm
Height	818 mm
Installation compartment width	600 mm
Installation compartment height (max)	880 mm
Installation compartment height (min)	820 mm