Electrolux KECA7300L - Page 11

Settings Values Description
Latest prog. selec‐
tion （最近的程序
选择）
ON （开）
OFF （关） (de‐
fault)
Enable or disable the automatic selection
of the most recently used programme and
options.
1)
Display on floor
（地面上的显示）
ON （开） (de‐
fault)
OFF （关）
Activate or deactivate TimeBeam （时间投
影） .
1)
Brightness （亮
度）
From level 0 to lev‐
el 9
Adjust the brightness of the display.
Language （语
言）
List of languages
(default: English)
Set the preferred language.
Reset settings （重
置设置）
YES （是）
NO （否）
Reset the appliance to the factory settings.
PNC number
（PNC 编号）
Number Check the PNC number of your appli‐
ance.
1)
1)
For more details, refer to the information provided in this chapter.
6.1 Setting mode
How to navigate in setting
mode
You can navigate in setting mode using
滑动时控 selection bar.
BA C
A. Previous button
B. OK button
C. Next button
Use Previous and Next to switch
between the basic settings and to
change their value.
Use OK to enter the selected setting and
to confirm changing its value.
How to enter setting mode
You can enter setting mode before
starting a programme. You cannot enter
setting mode while the programme is
running.
To enter setting mode, press and hold
simultaneously and for about
3 seconds.
• The lights related to the
Previous, OK and Next are on.
• The display shows the first
available setting and its current
value.
How to change a setting
Make sure the appliance is in setting
mode.
1. Use Previous or Next to select the
desired setting.
The display shows the setting name and
its current value.
2. Press OK to enter the setting.
The display shows available values.
3. Press Previous or Next to change
the value.
4. Press OK to confirm the setting.
• The new setting is saved.
• The appliance returns to the basic
settings list.
5. Press and hold simultaneously
and for about 3 seconds to exit
setting mode.
ENGLISH 11