Problem Possible cause Solution
Water flows inside the re‐
frigerator.
Food products prevent the
water from flowing into the
water collector.
Make sure that food prod‐
ucts do not touch the rear
plate.
The water outlet is clog‐
ged.
Clean the water outlet.
Water flows on the floor. The melting water outlet is
not connected to the evap‐
orative tray above the com‐
pressor.
Attach the melting water
outlet to the evaporative
tray.
Temperature cannot be
set.
The FastCool function is
switched on.
Switch off FastCool func‐
tion manually, or wait until
the function deactivates
automatically to set the
temperature. Refer to
"FastCool function" sec‐
tion.
The temperature in the ap‐
pliance is too low/too high.
The temperature is not set
correctly.
Set a higher/lower temper‐
ature.
The door is not closed cor‐
rectly.
Refer to "Closing the door"
section.
The food products' temper‐
ature is too high.
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
Many food products are
stored at the same time.
Store less food products at
the same time.
The door has been opened
often.
Open the door only if nec‐
essary.
The FastCool function is
switched on.
Refer to "FastCool func‐
tion" section.
There is no cold air circula‐
tion in the appliance.
Make sure that there is
cold air circulation in the
appliance. Refer to "Hints
and tips" chapter.
DEMO appears on the dis‐
play.
The appliance is in the
demonstration mode.
To exit the demonstration
mode, press and hold the
OK button for approximate‐
ly 10 seconds until you
hear a long sound and the
display turns off for a short
time.
www.electrolux.com18
To Next Page
Loading...
