PROBLEM
Motorwill notstartor suddenlystops
Nosuction Vacuumcleanerdoesnotpick
up lintor dirt
POSSIBLECAUSES
Unit notconnectedto powersource
Switchnotturnedon
Themalcut-off hasoperated
Blockageinair path
Dustcupfull
DustCup Filter clogged
Hepa Filterclogged
DustCup Filter not inplace
Switchnotonpropersetting
Dustcup willnot lockintovacuumcleaner
Oulck Release handle will not lock into
vacuumcleaner
Brushroll will notturn Objectcaughtinbrush roll
* Turbonozzleclogged/selectedmodelsonly)
DustCup Filter not inplace
Telescopicwand isextended
Brushroll notpositionedproperly
Red 'check brush roll" or "check filter Brushrollnot operatingproperlyorfilter isclogged
_nd_catorhght_son
Note: Any servicin 9 of the vacuum ether than described in this manual shall only be performed by an authorized service representative.
SOLUTION
Pushplugsecurely_ntooutlet
• Tryanotheroutletor checkc_rcu_tbreaker
• Check plugandcord for damage
• Press powerswitchto 'carpet'or 'hardofioor'setting
• Correctthecause of motoroverheating Seethermalcut-offinformation
• Removeany obstructionsthat restrictairflowthroughhoseand;orvalve
clean outarea
Emptydustcup
• Removeand clean filter
Fine dustcanblockthe airflowthroughthefilterand reducesuctioneven
ifdustcup doesnot look full
• Removeand cleanfilter
• Filtermustbe infilter framefor correctperformance
• Makesure filter frameisinstalledproperlyinfilter coverfor dust cupas-
semblyto fit back intoplace
• Use 'carpet'settingforcarpettedfloors
• Use 'hardfloor'settingfor hard-surfacedfloorsand whenusingacces-
sories
• Removeand clean debrisfromturbo nozzle
• Locate dustcupfilter and insertintodustcup
• Place end of wand intoopening at back of vacuum and align ribs into
grooves
• Removethe obstruction(such as carpet fringe, string or sock ) Note
brush roll overloadprotectorw_llreset when vacuum _sturned off or un-
plugged
• Use 'hardfloor'settingwhen vacuumingfringeof rugs
• Check brushrollfor threadsand debris Cleanifneeded
• Makesure bothendsof brushroll arefreeof debrisand securedproperly
so rollcan rotatefreely
• Turn theunit offand unplugit,clearthe stall condition,then plug itback
inand pressON
• Removeand clean filters
To Next Page
Loading...
