D1099
D1100
B
A
B
A
0209
15
3
01106073
PageNotice Date
OPERATING
HANDBOOK
Additional instructions for using a machine with automatic fol-
ding
Even if your ironer is equipped with the automatic folding function, a "With folding/Without
folding" mode makes it possible for you to use your ironer without the automatic folding
function. In this case, you simply need to move the reception tank upwards in order to enable
the linen to leave the machine unfolded, and then select the "Without folding" function on the
command panel.
Ironing of small items of linen, wi-
thout using the feeding system or the
automatic folding system.
• Close the fl ap (A) so as to be able to
stand as close as possible to the ma-
chine.
• Leave the linen collector (B) in the
horizontal position to receive the small
items of linen as they are ironed.
Ironing with the automatic feeding
system and the automatic folding sys-
tem
• Open the fl ap (A) to allow the linen to
hang correctly during smoothing.
• Swing the linen collector (B) into the
vertical position to form a box with the
fl ap.
If the tank is in the wrong position to receive unfolded linen, an electronic device prevents
you from using the ironer in the folding mode, even if you have selected the folding mode via
the command panel. The message "Warning: tank position error" is then displayed on the
command panel.
To return to the automatic folding mode, you should select the "with folding" mode and then
lower the reception tank. The linen will then be released directly on to the reception table.
NOTE: to ensure easy handling of the reception tank, it is recommended that you
operate this manually from its centre (between the two arrows inlaid on the front
edge of the tank).
3. Method of use
To Next Page
Loading...
Need help?
General
