Need help?Do you have a question about the Electrolux GWH-275 R N and is the answer not in the manual?
General| Type | Gas Water Heater |
|---|---|
| Mounting Type | Wall-mounted |
| Chimney Type | Natural draft |
| Gas Type | Natural Gas |
| Minimum Gas Pressure | 1.3 kPa |
Highlights the appliance's ignition method using piezo electricity.
Describes the heat exchanger material for efficient heat transfer.
Explains the control mechanism for the pilot flame via the ignition knob.
Details the feature that automatically adjusts water flow.
Mentions the safety feature involving a thermocouple.
Details the appliance's off state and associated controls or procedures.
Explains the step-by-step process for lighting the pilot flame.
Details the operation of the water heater at its minimum power setting.
Details the operation of the water heater at its maximum power setting.
Describes the safety features and their function during operation.
Lists essential checks and preparations required before installation.
Provides instructions on how to physically mount the water heater.
Details the procedure for safely connecting the gas supply line.
Outlines the steps for putting the newly installed appliance into service.
Covers recommended procedures for regular upkeep and servicing.
Troubleshooting steps for situations with reduced water temperature output.
Troubleshooting for issues resulting in an increased hot water flow.
Troubleshooting for issues resulting in a decreased hot water flow.
Diagnosing and fixing problems related to the pilot flame not igniting.
Troubleshooting pilot flame stability and failure to remain lit.
Diagnosing intermittent shutdown issues where the unit stops working.
Troubleshooting concerning delays in the safety valve operation.
Procedure to verify the gas supply pressure for correct operation.
Steps to inspect and maintain the gas filter for proper flow.
How to measure and verify the burner pressure settings.
Instructions for replacing the pilot gas filter unit.
Verifying the functionality of the flue gas safety thermostat.
Testing the thermocouple's voltage output for proper function.
Procedure for inspecting the electric gas valve's magnetic function.
Instructions on how to clean the cold water intake strainer.
Steps to clean the pilot jet for optimal performance and ignition.
Procedure for visually inspecting the ignition electrode for spark generation.
Guide to safely replacing the piezo igniter unit.
To Next Page
