0209 20
3
3-4 cm
D1119
01106073
Page
Notice
Date
OPERATING
HANDBOOK
3. Method of use
• Turn the selection button to select the
mode :
- Automatic feed
- Semi-automatic feed
• Press the initialisation button to po-
sition the clamps in operating mode
(clamps in the centre of the machine).
Note: in the event of blockage or
stoppage of the machine, of restarting,
power failure or if this indicator begins
fl ashing, you must press this same
button again to reinitialise the feeder.
• Take a large edge of the sheet in your
hands and place one corner in one
clamp and the other corner in the other
clamp. Do not leave over 3 to 4 cm
outside the clamp.
To Next Page
Loading...
Need help?
General
