2313 1
6
01106073
PageNotice Date
OPERATING
HANDBOOK
Preventive maintenance of the ironer
Daily (8 h)
(at the beginning of each working day)
1. Check that the machine stops when you press the mobile safety protector (hand safety
device).
2. Check that the "emergency stop button" works correctly.
Weekly (40 h)
3. Clean motor ventilation grills.
4. Clean the drive system of the dewrinkling strips.
5. Clean the separators.
6. Clean the detection cell and its refl ector (on models with the folding function only).
7. Check and clean the fl uff fi lter and the cover fi lter with suction device.
Monthly (170 h)
8. Remove dust from outside the machine.
9. Check the condition of the separating ribbons, and replace them if necessary.
10. Ensure that the thermostatic regulation and overheat safety shoes are always clean and
in contact with the cylinder.
11. Lubricate the steam heater bearings (see lubrication chart in next pages).
Every six months (1000 h)
12. Check for any possible oil seepage, particularly at the fi ller plug (only on Dubixium cylin-
ders).
13. Grease chains (see lubrifi cation table on the following pages).
14. Clean and inspect the cylinder support rollers, along with the stop roller wear indicator
(except on the steam machine). If there is any premature wear, see technical support,
ref. 04102018.
15. Check operation of the handle.
16. Inspect tightness of electrical connections on the power supply terminal block and elec-
trical earthing connections.
17. Clean exhaust system.
18. Inspect heating elements, cables and electrical connections (on electrical heating only).
19. Clean gas fi lter inside the gas valve (on gas heating only).
20. Check the condition of ironing bands and their staples.
21. Check the feed bands and their drive and ejection bands (on models with the folding
funciton only).
22. Clean inside the machine.
6. Preventive maintenance
To Next Page
Loading...
Need help?
General
