0212 4
6
01106073
Page
Notice
Date
OPERATING
HANDBOOK
6. Preventive maintenance
Preventive maintenance of the feeder system
Daily (8 h)
(at the beginning of each working day)
1. Check that the "emergency stop button work correctly.
Weekly (40 h)
2. Clean motor ventilation grills.
3. Clean the drive system of the dewrinkling strips.
Monthly (170 h)
4. Remove dust from outside the machine.
5. Check the condition of the separating ribbons on the press roller, and replace them if ne-
cessary.
Every six months (1000 h)
6. Inspect tightness of electrical connections on the power supply terminal block and electri-
cal earthing connections.
7. Clean exhaust system.
8. Remove dust from inside the machine.
WARNING
Carry out these instructions at regular
intervals, depending on the frequency
of use, to keep your machine in opti-
mum working condition.
Note:
The drier-ironing machine textile components must be considered as wearing parts. The lifetime of
these parts (ironing strips, feeding strips, clamping belts, transfer belts, etc.) is highly dependent on
the usage conditions and maintenance frequencies. Consequently, their replacement may not be
claimed under any guarantee.
To Next Page
Loading...
Need help?
General
