Problem Possible cause Solution
Temperature cannot be
set.
The FastFreeze or FAST‐
COOL function is switch‐
ed on.
Switch off FastFreeze or
FASTCOOL manually, or
wait until the function resets
automatically to set the tem‐
perature. Refer to "Fast‐
Freeze or FASTCOOL func‐
tion".
DEMO appears on the
display.
The appliance is in dem‐
onstration mode.
Keep the mode key pressed
for approximately 10 sec‐
onds until a long sound is
heard and display shuts off
for a short time.
The temperature in the
appliance is too low/too
high.
The temperature regulator
is not set correctly.
Set a higher/lower tempera‐
ture.
The food products tem‐
perature is too high.
Let the food products tem‐
perature decrease to room
temperature before storage.
Many food products were
stored at the same time.
Store less food products at
the same time.
The FastFreeze function
is switched on.
Refer to "FastFreeze func‐
tion".
The FASTCOOL function
is switched on.
Refer to "FASTCOOL func‐
tion".
Side panels of the appli‐
ance are warm.
This is a normal state
caused by operation of
the heat exchanger.
Make sure that there is at
least 30 mm of space be‐
tween each side of the appli‐
ance and the surrounding
furniture when the ambient
temperature exceeds 38°C.
There is too much con‐
densed water on the rear
wall of the refrigerator.
Door was opened too fre‐
quently.
Open the door only when
necessary.
Door was not closed com‐
pletely.
Make sure the door is closed
completely.
Stored food was not
wrapped.
Wrap food in suitable pack‐
aging before storing it in the
appliance.
Door does not open easi‐
ly.
You attempted to re-open
the door immediately after
closing.
Wait a few seconds between
closing and re-opening of the
door.
ENGLISH 57
To Next Page
Loading...
