3. Unscrew the upper hinge and
remove the cover on the left side of
the door (cover available in selected
models). Install the upper hinge on
the opposite side, do not tighten the
screws. Put the cover in the hole on
the right side of the door.
4. Remove the door.
5. Tilt back the appliance carefully, so
that the compressor does not touch
the floor.
6. Unscrew the left foot and the screw.
7. Unscrew the screws of the door
bottom hinge. Remove the hinge.
Position the pin in the neighbouring
hole of the bottom hinge.
8. Unscrew and install the screws on
the opposite side of the bottom
hinge.
9. Install the bottom hinge on the left
side.
10. Screw in the screw and the right foot.
11. Fit the appliance door on the bottom
and upper hinge pins.
12. Tighten the screws of the upper
hinge.
13. Slide the top forward into the right
position.
14. Screw in both screws on the rear
side.
15. Remove and install the handle on the
opposite side.
CAUTION!
Reposition, level the
appliance, wait for at least
four hours and then connect
it to the power socket.
ENGLISH 7
To Next Page
Loading...
