14 English
Emptying and Cleaning the Dust Collector
Cleaning the Roller
1. Press the button on the rear
side of Trilobite, and ...
2. ... lift off the lid. 3. Take out the dust collector. 4. Remove the grille with the
opening facing up.
5. Empty the collector
(preferably in a plastic bag
fit snugly around the unit).
Do not knock the
collector against hard
surfaces to empty it. Always
replace with a new filter.
1. Check the roller each time
the dust collector is
emptied. Begin by lifting
Trilobite by the handle.
2. Turn Trilobite upside down
and put it on a soft surface
with the display facing you.
3. Push the locking knob to the
right.
4. Raise the cover. 5. Lift the roller by the end
without a drive belt.
Remove it by holding it
at an angle and pulling
upwards/outwards.
To Next Page
Loading...
