Electrolux TWINSTREAM - Shampooing Operation Steps

preformed slots on the shampoo
air/tubing (Fig. 8)
4) Tne shampoo tank holds a
maximum of 3.2 litres G litres of
water and 200 mi of shampoo).
When using shampoo mix with
warm tap water.
IMPORTANT:
In order for the Twinstream to
work effectively the fwo. Air
Injection outlets must be open.
Slide the lever from left fo right as
per figure 9. Place the shampoo
tank on the power unit and click
into place.
5 Insert the two ends of the
shampoo and air tube into the
connectors at the front of the
shampoo tank.
Tubing with metal valve fits into the
metal connector.
Tubing with black plastic valve fits
into larger diameter hole (Fig. 10).
Note: When cleaning hard floors
place the adaptor onfo the
nozzle (see fig. 12).
USING THE APPLIANCE TO
SHAMPOO
Press the on/off switch on the upper
part of the appliance to start the
motor.
Position the nozzle in working position
on the floor, pull the trigger and wait
for a few seconds until the shampoo
starts to spray from the nozzle.
Start to clean the surface from the
point furthest from the entrance door
of the room.
Draw the nozzle slowly towards
yourself, pressing the trigger and
gently holding the nozzie against the
carpet (see Fig. 17 e 12).
Release the trigger and go over the
cleaned area several times to dry.
Continue the cleaning operation
parallel to the area already
cleaned, with a slight overlap to
ensure that no part of the surface is
left untreated.
To remove the shampoo tubing press
the button on the top of the
connector until the tubing pops out
(see fig. 11).
To remove the air tubing, turn
anti-clockwise and pull out.
Remove shampoo tank.
Before storing the appliance rinse
out the shampoo tank and dirty
water drum.
Always ensure that the — dirty
water/dust tank is dry before
replacing the dustbag and dry filters.
Cable storage
After use the cable can be wound
around the storage area beneath
the power unit (Fig. 13).
FILTER CLEANING (Fig. 14)
IMPORTANT
It is essential fo keep all filters clean
and unclogged.
For efficent performance all filters
should be checked for blockages
regularly in the following way.
Paper filfer
Keep a small stock of these and fit a
new one when the old one
becomes clogged.
Cloth filter
Brush the filter, wash if with soapy
water, then dry if completely and
return if to its housing.
Round foam motor filter (Fig. 6 and
6a).
This is housed inside the basket.
Check regularly. To clean remove
the basket by twisting and gently
pulling it away from the power unit.
Wash the filter in warm water and
dry thoroughly. Repiace it in the slots
“‘é