make any change, you must pause the
washing machine by pressing the button 7 .
Changing a running programme is possible
only by resetting it . Turn the programme
selector dial to
and then to the new pro-
gramme position. Start the new programme
by pressing the 7 button again. The washing
water in the tub will not emptied out.
Interrupting a programme
Press the button 7 to interrupt a programme
which is running, the corresponding light
starts blinking. Press the button again to re-
start the programme.
Cancelling a programme
Turn the selector dial to
to cancel a pro-
gramme which is running. Now you can se-
lect a new programme.
Opening the door after the programme
has started
First set the machine to pause by pressing
the button 7 . If the pilot light 8.2 goes off,
after some minutes the door can be opened.
If the door remains locked - the pilot light
8.2 is on, this means that the machine is al-
ready heating, that the water level is above
the bottom edge of the door. In this case the
door can not be opened. If you cannot open
the door but you need to open it you have to
switch the machine off by turning the selector
dial to
. After some minutes the door can
be opened (pay attention to the water lev-
el and temperature !) .
After closing the door, it is necessary to se-
lect the programme and options again and to
press button 7 .
At the end of the programme
The machine stops automatically, the pilot
light of button 7 , the pilot lights 8.1 and 8.2
go off and a blinking
will appear on the
display. Some acoustic signals sound. The
door can be opened.
If a programme or an option that ends with
water still in the tub has been selected, a
blinking
will appear on the display, the pilot
light 8.2 illuminates, the pilot light of button
7 goes off and the door remains locked to
indicate that the water must be emptied out
before opening the door.
Follow the below instructions to empty out
the water:
•
Turn the programme selector dial to
• Select the draining or spinning programme
• Reduce the spin speed, if needed, by
pressing the relevant button
•
Press button 7 to start the programme
• When the programme has finished the dis-
play shows a blinking
. The pilot light
8.2 goes off and the door can be opened.
Turn the programme selector dial to
to
switch the machine off. Remove the laundry
from the drum and carefully check that the
drum is empty. If you do not intend to carry
out another wash, close the water tap. Leave
the door open to prevent the formation of
mildew and unpleasant smells.
Stand by : once the programme has finished
after a few minutes the energy saving system
will be enabled. The brightness of the display
is reduced. By pressing any button the ap-
pliance will come out of the energy saving
status.
Helpful hints and tips
Sorting out the laundry
Follow the wash code symbols on each gar-
ment label and the manufacturer’s washing
instructions. Sort the laundry as follows:
whites, coloureds, synthetics, delicates,
woollens.
Before loading the laundry
Never wash whites and coloureds together.
Whites may lose their «whiteness» in the
wash.
New coloured items may run in the first wash;
they should therefore be washed separately
the first time.
Button up pillowcases, close zip fasteners,
hooks and poppers. Tie any belts or long
tapes.
Remove persistent stains before washing.
Rub particularly soiled areas with a special
detergent or detergent paste.
Treat curtains with special care. Remove
hooks or tie them up in a bag or net.
electrolux 9
To Next Page
Loading...
