What does error message F1 mean on my Electrolux WEK 7 Wine Cooler?
If you see an error message F1 on the operation panel of your Electrolux Wine Cooler, it indicates that the top sensor is defect. The solution is to replace the sensor.
What does error message F2 mean on my Electrolux Wine Cooler?
If you see an error message F2 on the operation panel of your Electrolux Wine Cooler, it means that the bottom sensor is defect. To resolve this, replace the sensor.
How to fix an Electrolux WEK 7 Wine Cooler that is not working?
If your Electrolux Wine Cooler isn't working, here are a few things to check: * First, the appliance could be in a 5-minute forced interruption mode for pressure compensation. Try switching it on again. * Make sure the plug is fully inserted and not loose. * Check the fuse to see if it's defect and replace it if needed. * The power outlet itself might be defect; in that case, have it repaired by an electrical specialist. * Finally, ensure that the presentation mode is deactivated.
Why is the interior light not working in my Electrolux WEK 7 Wine Cooler?
If the interior light of your Electrolux Wine Cooler isn't working, it could be due to several reasons: * The LED might be defect and needs replacing. * The LED plug might not be correctly inserted, so inspect the plug-in connection. * The magnet might be missing or incorrectly fitted, so check the light switch. * The sensor could be bent, making the magnetic field ineffective, so align the sensor. * The permanent mode might be activated, so try deactivating it.
What to do if my Electrolux WEK 7 is not cooling enough?
If the chilling temperature in your Electrolux Wine Cooler is insufficient, consider the following: * Check if the temperature is set correctly by referring to the operating functions. * Avoid leaving the door open for more than 2-3 minutes. * Other potential issues include a ventilator defect (replace the ventilator), a door seal problem (replace the door seal), or the appliance being too close to a heat source (refer to the instruction manual for placement guidelines). * Also, inspect the glass door for cracks or if it's mounted canted; replace or adjust as needed. * If you notice irregular operating sounds, the compressor might be defect, requiring repair by a specialist due to explosion risk.
Why is there condensation on the door of my Electrolux WEK 7?
If you notice condensation forming on the door of your Electrolux Wine Cooler, it's likely due to increased atmospheric moisture. Wipe it off with a dry cloth and set the temperature a little warmer.
Why is there insufficient temperature difference top/bottom in my Electrolux WEK 7?
If you're experiencing an insufficient temperature difference between the top and bottom of your Electrolux Wine Cooler, here are some possible causes and solutions: * The cooling temperature might be too cold, so adjust it correctly. * A sealing lip might be missing from the false floor, so fit a sealing lip. * The false floor itself might be missing, so mount it. * Other potential issues include a heating defect (inspect the heating), a defective air flap control (inspect the servomotor), or an air flap jam (remedy the malfunction). * Also, check if the sensors are exchanged and connect them correctly if needed.
General| Brand | Electrolux |
|---|---|
| Model | WEK 7 |
| Category | Wine Cooler |
| Language | English |
To Next Page