Electrolux Wine cooler - Door Reversal; Reversing the Door

9
Door Reversal
Reversing the Door
This model comes equipped with a RH-swing door.
To convert the unit to a LH-swing door (as shown
in the Use & Care Guide), certain components
must be obtained before beginning the conversion.
These components are available from your local
dealer or by calling Electrolux.
Order Part Number: 5303418377
To reverse the door:
1 Disconnect power to the wine cooler.
2 Remove toe grille by removing two screws.
3 Disconnect door harness from connector
bracket behind lower front panel. Pull
harness from behind lower front panel so it is
hanging below the door.
4 Remove upper right-hand (RH) hinge
bracket by loosening four screws. Be careful
to support the door while loosening and
removing the upper hinge bracket.
5 Lift the door off of the lower RH hinge
bracket. Turn the door upside down and place
on a soft, non-abrasive surface.
Remove
Toe Grille
Remove
2 Screws
Pull Harness Out Below Door
Disconnect
Connector
From Bracket
Bracket
Remove
Hinge Cover
(Some Models)
Remove 4
Screws and
Hinge Bracket
Support
Door
During
Removal
Door
Lift Door Off Lower
Door Hinge
Hinge