Problem Possible cause Solution
The light button is not op‐
erating.
Contact the Authorised Serv‐
ice Centre.
Too much vibration. The appliance is not sup‐
ported properly.
Check if the appliance
stands stable.
The appliance is noisy. The appliance is not sup‐
ported properly.
Check if the appliance
stands stable.
Water flows on the rear
plate of the appliance.
During the automatic de‐
frosting process, frost
melts on the rear plate.
This is correct.
Water flows inside the
wine cabinet.
The appliance drains are
clogged.
Clean the appliance drain
holes Refer to the "Cleaning
the drain" section.
Water flows inside the
wine cabinet.
Products prevent that
water flows into the water
collector.
Make sure that products do
not touch the rear plate.
The temperature in the
wine cabinet is too low or
too high.
The temperature regula‐
tor is not set correctly.
Set a higher or lower tem‐
perature.
The door is not closed
correctly.
Refer to the "Closing the
door" section.
If the advice does not lead to
the desired result, call the
nearest Authorised Service
Centre.
9.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
9.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to the "Installation" chapter.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
ENGLISH 75
To Next Page