Electrolux WKU60DSP - Troubleshooting

3. Clean the appliance and all
accessories.
4. Leave the door open to prevent
unpleasant smells.
When the appliance is not in use due to
power failure:
• Most power failures are corrected
within a few hours and don't affect the
temperature of your appliance if you
minimize the door opening.
• If the power is going to be off for a
longer time, you need to take the
proper steps described above.
9. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
9.1 What to do if...
Problem Possible cause Solution
The appliance does not
operate.
The appliance is switch‐
ed off.
Switch on the appliance.
The mains plug is not
connected to the mains
socket correctly.
Connect the mains plug to
the mains socket correctly.
There is no voltage in the
mains socket.
Connect a different electrical
appliance to the mains sock‐
et, to check if electricity is
flowing. If not, contact a
qualified electrician.
The circuit breaker trip‐
ped or a blown fuse.
Turn on the circuit breaker or
change the fuse.
The compressor operates
continually.
Temperature is set incor‐
rectly.
Refer to the "Operation"
chapter.
The room temperature is
too high.
Refer to the "Installation"
chapter.
The door is opened too
often.
Do not keep the door open
longer than necessary.
The door is not closed
correctly.
Refer to the "Closing the
door" section.
The light does not work. The light is turned off. Turn on the light. Refer to
the "Light setup" section.
The appliance is not
plugged in.
Connect the appliance.
The circuit breaker trip‐
ped or a blown fuse.
Turn on the circuit breaker or
change the fuse.
The lamp is defective. Contact the Authorised Serv‐
ice Centre.
www.electrolux.com74