Need help?Do you have a question about the Electronics International CGR-30P and is the answer not in the manual?
General| Brand | Electronics International |
|---|---|
| Model | CGR-30P |
| Category | Monitor |
| Language | English |
Describes the three primary hardware groups: Probes/Transducers, the Engine Data Converter (EDC), and the CGR Display Unit.
Explains the usage of the SELECT knob and the SCREENS/EXIT buttons for device navigation and control.
Divides the Main Screen into four key areas: RPM/MP, Horizontal Strip Gauges, Bar Graph, and EGT/CHT Digital Gauges.
Explains the six operating modes of the Bar Graph Analyzer for EGT/CHT monitoring and engine diagnostics.
Explains the K-Factor's role in accurate fuel flow measurement and how to adjust it for optimal performance.
Allows K-Factor adjustment for accurate fuel flow, not accessible during engine operation.
Configures EGT/CHT bar graph display, including range settings and hottest-to-coldest difference.
Lists screens for configuring the CGR-30P for a specific aircraft, which are password protected.
Allows software updates and backup/retrieval of configuration files from USB storage.
Sets engine parameters like cylinder count and #1 cylinder location for bar graph display.
Allows setup of fuel tanks for estimating fuel levels, detailing advantages and disadvantages.
Calibrates horsepower calculation using engine data from POH and flight measurements.
Configures most displayed functions, including parameters, units, gauge types, and screen placement.
Allows calibration parameter changes for a probe connected to a function, including source and gain.
Relates sensor input values to displayed values for calibrating fuel tanks and other functions.
To Next Page
