-13-
Set Status Reply
On receiving an Set Status request message, the system returns a status message to
the sender. This message includes the system status and the descriptor of the user or
the device used to set/unset the system.
The following example shows an Set Status reply where the system has been fully
armed by a user named Mark.
F U L L A R M E D - M A R K
3.6: Remote Setting/Unsetting via the Telephone
Using the Telecontrol feature, you can “Full” set and unset the system via the telephone.
For further information on the Telecontrol features, see Chapter Six: Telecontrol.
To Next Page
Loading...
