How to use Electrorad Aeroflow Heater in manual mode?
To use your Electrorad Heater in manual mode, go into the configuration menu. When you see ‘programmes on’, press OK to switch to ‘programmes off’.
What to do if Electrorad Aeroflow Heater is not working?
If your Electrorad Heater isn't working, first, turn off the electricity supply at the mains. Then, check the fuse in the fused spur or plug. Lastly, ensure the male to female connection that joins the end panel to the radiator is tight.
Why Electrorad Heater is not achieving my set point?
If your Electrorad Heater isn't reaching the set point, consider the following: Is your radiator appropriately sized for the space? If it's not powerful enough, you may need a larger or additional radiator. Also, check if the radiator is near a frequently opened door or window. To disable the open window feature, navigate to the configuration menu and select ‘Open window detection’ then press OK.
What to do if Electrorad Aeroflow Heater is heating at wrong times?
If your Electrorad Heater is heating at the wrong times, make sure you have set it up correctly by selecting ‘see’ in the programmes parameter. If needed, re-program the radiator. Verify that you are in programming mode and that the correct time is set on the radiator. Also, check if the radiator is reading the correct temperature and calibrate the sensor probe if necessary.
Why Electrorad Aeroflow app is not picking up all radiators?
If the app isn't consistently detecting all of your Electrorad radiators, try shutting down and reopening the app. Also, confirm that all radiators were initially paired. Ensure that your router isn't surrounded by electrical interference or items that could block the signal.
Why Electrorad Aeroflow is tripping RCD?
If your Electrorad Heater is tripping the RCD, turn off all other electrical appliances on the ring main and try again. Also, check all electrical connections in the plug/fused spur.
What to do if Electrorad Aeroflow is reading the wrong temperature?
If your Electrorad Heater is displaying an incorrect temperature, calibrate all radiators after they have been installed for 24 hours. Use a separate thermometer to measure the temperature within half a meter of the sensor probe and then calibrate the temperature that the radiator is reading accordingly.
Why Electrorad Aeroflow is beeping or showing wrong temperature?
If your Electrorad Heater is beeping, or the sensor probe shows a significantly incorrect temperature, it might be because the thermostat has come loose from the controls. Ensure the wire is securely connected and tight.
Explains radiator interface symbols and provides attachment dimensions for installation.
Guide to operating the radiator using manual control and set points for desired temperature.
Overview of setting heating schedules and automated operation for consistent comfort.
Instructions for connecting and controlling the radiator via a mobile application.
Instructions on how to add and pair radiators with the Aeroflow app for remote control.
Guide to creating custom heating schedules and programs through the mobile app.
Instructions for configuring heating schedules for multiple radiators simultaneously.
Addresses issues with radiator-to-app pairing and device detection.
Diagnoses and resolves problems related to radiator heating performance and temperature readings.
Guidance on operating the radiator in manual mode and setting temperatures.
Instructions on how to effectively turn off the radiator or use holiday mode.
Troubleshooting steps for non-functional radiators or persistent fault indicators.
General| Brand | Electrorad |
|---|---|
| Model | Aeroflow Series |
| Category | Heater |
| Language | English |
To Next Page
