Electroswitch 25-1000 - Control Panel Description

25-1000-UM 6
Control Panel Description
1. Main measurement display (upper
readout)
Measurement display: Battery voltage,
+bus voltage, -bus voltage, ground fault
voltage, ripple voltage, ripple current (with
optional sensor), time delay and AC input
mode (single or 3 phase)
2. Parameter/Setup Menu display
(lower readout)
Indicates parameters displayed in the
upper readout and fault indications
3. Alarm LED
Indication for all alarm conditions
4. Reset button
When in latch mode, resets all alarm relays
and alarm indications
5. Limit button
Used to navigate setup menu
6. T/R bi-color LED (Green/Red)
Indicates transmit or receive operation, Red-Transmitting / Green-Receiving
7. Auto LED
Indicates Auto-Scanning (scrolling) mode
8. Up button
Increases limit set point and calibration values (press and hold to increase rate)
9. Down button
Decreases limit set point and calibration values (press and hold to increase rate)
10. Pulse on LED
Indicates internal pulse generator is activated
11. Scan/Manual Button
Toggle between Auto and Manual mode then scrolls through all the readings and set points
12. Buzzer
Located behind the bezel
12
1
2
4
5
7
8
6
9
10
11
3