Hybrid Stereo Pre-amplifier
Content
Cautions
Necessary Tools
1.Parts List
2.Circuit board assembly
3.Wiring, assembly, operation check,
and usage
4.Technical Data
5.Warranty
875-06
Long Nose Pliers
Solder
( 0.8~1.0mm)
Soldering iron(15~30W)
Diagonal-Cutter
Screwdriver
(No.2)
Solder Stand
Pen Knife
Scissors
Hexagonal wrench (1.5mmE2.5mm)
Multimeter
NECESSARY TOOLS
1
CAUTIONS
For your own safety, please read the "Assembly Instruction Manual" carefully
before you begin assembing this preamp kit.
Please follow the instruction step by step for correct assembly.
Do not work near any source of water or allow any components to get wet which may cause fire and electric shock.
Do not put containers with w ater on the work table such as v ases, cups, cosmetics, and drugs. Spilling water on components
will cause fire and electric shock.
Keep out of reach of small children during assembly, usage and storage. Please discard packing waste and any waste from
assembling the kit according to social standard for safety and protection of the en viroment.
Read the "Assembly Instruction Manual" carefully and be sure to f ully understand the instructions bef ore assembling.
Be careful when handling tools; diagonal cut ters, pen knives, and other sharp tools in particular.
Do not work near young children due to safety concerns. Children must not play with tools, plastic bags and electronic parts as they
may cause harm.
Some essential pieces in this kit include small and sharp objects that are made of glass or metal. Be extremely careful. If by
any chance a child has swallowed any of these items, immediately consult a medical doctor.
This product and its components may differ without notice.
ƒPlease keep this instruction manual handy at all times.
Lot.No.
EK JAPAN 1999
2-19-30, Tofuro-Minami, Dazaifu City, Fukuoka, 818-0105, Japan
EK JAPAN's homepage: www.elekit.co.jp
E-mail: info@elekit.co.jp
TU - 875 Assembly Instruction Manual
1
1
2
3
6
14
16
Features
This is a simple preamplifier without tone control. The pre- amplifier has a volume and
balance control, a phono equalizer and a MC head amp. It is also compatible with /
a MM/MC cartridge.
A hybrid construction using J-FET with a MC head amp and equalizer to give a low
noise effect without compensating the quality of music produced by the tubes.
An AC adapter (DC 7V stabilized power outlet) is separate and is used as a power
supply. A secondary power for the vacuum tubes is supplied by a steady DC 200V
from the DC-DC converter of a sealed box. With the main body and power supply
separated, the electromagnetic hum-noise is reduced.
The pop noise muting circuit uses a relay method rather than an analog switch to
prev ent sudden large amplitude response of the tubes. The LED light, which indicates
power input, will blink from power on to muting cancellation.
LINE-1 and LINE-2 are compatible with monophonic sources. When plugged into the
L-side alone, the R-side will be automatically turned on.
A printed circuit board is included f or easy assembly.
EK JAPAN CO. , LTD.
has a volume and
com
To Next Page
Need help?
General