To Next PageTo Next Page
Need help?Do you have a question about the Elektra Beckum 170-230 and is the answer not in the manual?
General| Mains voltage | 230 V |
|---|---|
| Fuse (slow-blow) | 16 A |
| Open circuit voltage | 48 V |
| Welding current range | 30-170 A |
| Protection class | IP 21 |
| Insulation class | H |
| No-Load Voltage | 48 V |
| Electrode diameter | 1.5 - 4.0 mm |
| Duty Cycle | 60% at 130 A |
Outlines user obligations for machine operation, maintenance, and modifications.
Crucial safety guidelines for electrical protection, UV rays, burns, and fumes during operation.
Explains technical parameters and symbols for welding output specifications.
Guides on connecting cables, gas cylinder, and initial machine setup for operation.
Details connection procedures for single-phase and three-phase power supplies.
Specific instructions for connecting Combi models to 230V/400V power supplies.
Safety step to disconnect the machine from mains power before spool installation.
Instructions on adjusting the feed roller and spacer washers for different wire diameters.
Steps for guiding welding wire through the torch lead assembly and setting tension.
Table and guidance for setting wire feed speed based on welding step and wire diameter.
Specific components and gas flow settings required for welding aluminium.
Guidance on shielding gas, torch setup, and recommended settings for stainless steel.
Explanation of symbols and functions for stitch and spot welding modes.
Steps for attaching the earth clamp, setting current, and wire feed speed.
Guidance on proper earth connection and calculating shielding gas flow rates.
