QUICK START GUIDE10 FOR SUPPORT, VISIT ELEMENTELECTRONICS.COM/SUPPORT 11
1
3 4
2
HOW TO INSTALL
THE CORD HOOKS
HOW TO CLEAR
A BLOCKAGE
If vacuum is not cleaning oors, or if there is
no suction at end of the hose, check to be
sure the air path is not blocked.
• Press release button and lift off
dust cup (Fig. 1).
• Empty debris. Hold over wastebasket
and press lever to release bottom lid
(Fig. 2).
• Check lter and lter screen.
Remove any debris and shake off dust.
(See maintenance instructions on page 9.)
• Loosen end of hose.
• Use a rod or similar blunt implement to
clear a blockage in wand or hose. Flex
hose to loosen debris (Fig. 3). Use
caution if there is any risk that glass
or nails could have become imbedded
in hose.
• Use nger to check for debris in air path (Fig. 4).
• Reinstall lter and lter screen inside dust cup
and position dust cup onto vacuum cleaner.
Warning: Never operate vacuum cleaner without
foam lter, lter screen and dust cup in proper position.
Caution: Make sure vacuum
is turned off and power
cord is unplugged.
Step 1: Align the upper cord hook
with the upper connector. Push until
it snaps into place. Ensure the cord
hook can rotate freely.
Step 2: Align the lower cord hook
with the lower connector. Ensure
the rounded edge of the cord hook
is pointing downward, as shown.
Push until it snaps into place.
This cord hook should not rotate.
Upper Cord Hook Lower Cord Hook
To Next Page
Loading...