System Setup
System Setup
DIGITAL AUDIO SETUP PAGE
AUDIO SETUP PAGE:
ANALOG AUDIO SETUP:
DOWNMIX:
LT/RT: The audio out is Left and Right channel formatting even if the original sound is 5.1CH format.
STEREO: The audio out format is stereo even if the original sound is 5.1CH format.
3D SURROUND: The audio out is virtual surround sounds (only for 5.1CH player)
OFF: Turn off DOWNMIX function. If playing 5.1CH discs or the unit is connected with 5.1 channel
amplifier, this item should be selected.(only for 5.1CH player)
FRONT, CENTER, REAR and SUB-WOOFER SPEAKER: (No this item in 2CH player)
If your speaker system includes the above speakers, you can set these items according the real
speaker status.
TEST TONE In this mode you can test the speaker.
DIALOG: The DIALOG mode is available, and you can press up and down direction key to adjust
it. (In the DOWNMIX mode, LT/RT or STEREO is selected.)
D.R.C: The D.R.C can control data record. You can chose AUTO, ON and OFF in this mode.
DIGITAL OUTPUT:
SPDIF OFF: No digital output(optical or coaxial off), only analog audio output.
ALL: If this item is selected, you can set up RAW.
PCM ONLY: In SPDIF/PCM mode, setup PCM channel according to your preference.
LPCM OUT :
Select PCM frequency at 48kHz or 96kHz.
Note: Some amplifiers don't support 96kHz sampling which will effect the coaxial/optical output.
DUAL MONO:
Stereo: Set audio output to the stereo output.
L-mono: Set audio output to the mono-left channel.
R-mono: Set audio output to the mono-right channel.
Mix-mono: Set audio output to the mix-mono channel.
DYNAMIC:
Select this to reduce the overall volume and still keep defined audio sound.
You can press up and down direction key to adjust it.
DOLBY DIGIT AL SETUP
CHANNEL DELA Y PAGE:
If the above setup dissatisfy you, you can set the speaker distances in the real conditions. Press
up/down direction key to select the speaker, and press left/right direction key to adjust the
distance.
EQUALIZER:
In this item you can set sound mode, bass boost, super bass ans treble boost. You can select
one according to your preference and the disc content.
3D PROCESSING:
In PROLOGIC ON mode, the reverb mode setup is available.
HDCD SETUP:
You can select the digital filter at off,1x and 2x.
KARAOKE: (No this function in some types of machine)
KARAOKE can be controlled to output by the setup menu. There are 2 optional output modes: ON/OFF .
Adjust microphone volume to the minimum level. Insert microphone into the microphone jack.
Use the microphone volume knob to adjust the microphone volume.
When playing karaoke disc, to eliminate the original singing, press [L/R/ST] key on the
remote controller to select left channel or right channel. When playing DVD disc, press
[AUDIO] to eliminate its original singing.
MIC VOL
MIC
To Next Page
Loading...