2
Mind Reader Game
Build the circuit below. It uses a paper clip and a
3-Snap Wire as “shorting bars”.
Setup: Player 1 sets the target by placing the
3-snap shorting bar under the paper on column
2, 3 or 4. Player 2 must NOT know where the
shorting bar is located under the paper.
The object is for Player 2 to guess the location by
placing one end of the paper clip on the 5-snap
wire as shown, and the other end of the paper clip
at positions X, Y, or Z and then pressing the press
switch (S2). If Player 2 places the paper clip at
the correct position, the sounds played indicates
a “hit”. He keeps guessing until he hits. After each
hit, remove the 3-snap shorting bar and slide the
switch off and on to reset the sound.
Player 2 then sets the 2, 3, 4 side and player 1
tries his luck.
Play multiple rounds and see who gets the best
overall score. The winner will be the player who is
best at reading his opponent’s mind.
Paper Sheet to
hide position of
shorting bar
Project 60
To Next Page
Loading...
