Elentek SMART PRO LED 2-Mono

Need help?

Do you have a question about the Elentek SMART PRO LED 2-Mono and is the answer not in the manual?

Summary

2. WARNINGS

3. OVERVIEW

4. INSTALLATION

5. LIGHT INDICATORS AND COMMANDS

6. MAIN BOARD INPUTS AND OUTPUTS

8. MOTHERBOARD DIP-SWITCH SETTINGS

8.1 DIP-SWITCH 1 - Level alarm signalling from probes input

Configures level alarm signalling from probe input or minimum level float.

8.2 DIP-SWITCH 2 - Ammeter trip delay

Selects the thermal switch activation delay time to 5 or 10 seconds.

8.3 DIP-SWITCH 3 - Klixon input deactivation

Enables or disables the Klixon input for motor overtemperature control.

8.4 DIP-SWITCH 4 - Alarm reset enable from motor Klixon

Determines if motor overtemperature alarm reset is manual or automatic.

8.5 DIP-SWITCH 5 - Filling;Emptying mode probe input

Selects probe input usage for filling or emptying/pressurization modes.

8.6 DIP-SWITCH 6 - Self-holding enable (start;stop floats)

Activates self-holding function for start/stop floats, suitable for wastewater emptying.

8.7 DIP-SWITCH 7 - Delayed board activation enable on mains power return

Enables a delayed board activation (30 seconds) after mains power return.

8.8 DIP-SWITCH 8 - Motor switching module enable

Enables automatic switching of motors, alternating output on calls or operating both.

9. DIP-SWITCH SETTINGS DISPLAY

10. TRIMMER SETTINGS

10.1 TRIMMER SENS. PROBE - Probe sensitivity

Adjusts sensor sensitivity to adapt to liquid conductivity levels.

10.2 TRIMMER MIN - Activation on minimum current

10.3 MAX TRIMMER - Activation on current overload

12. STANDARD WIRING DIAGRAMS

12.1 SMART PRO Single phase (230 V) wiring diagram

12.2 SMART PRO Three phase (400 V) wiring diagram

13. EXPANSION WIRING DIAGRAMS

14. WIRING DIAGRAMS

15. RS485 MODBUS ADDRESSES

17. TROUBLESHOOTING