6
place into the water in the back part of the boat or we throw it
behind ourselves while electrofishing in brooks or streams. To
the socket START we insert the steering cable to the maximum
end.
When electrofisher is correctly connected we can start
fishing dipping the landing net in water and pressing press-
release button. The (-) minus cable with metal wire at the end
must ALSO be dipped into the water. Fishing takes place by
periodic/short pressing the button START on landing net while it
is under water surface. The (-) minus cable with metal wire at the
end and the cable (+) plus must be in the distance of 3 meters
and in case of catfishing it can be greater even 20 meters. In this
moment flow of electric current follows between electrodes and
executes the fishing. You should hear silent noise and blinking
green lamp on the device as well as display showing operating
parameters.
In the course of electrofishing negative (-) electrode is
placed in water "freely" and positive electrode (anode)(+) serves
to active fishing. Intensity of current field is the greatest at
positive electrode and ąuickly diminishes with the distance from
it. In regard with this fishes become paralysed in the radius not
greater than 2-5 metres from anode. Inertly flowing fishes we
should pick up ąuickly because in the course of several seconds
they recover equilibrium and escape at random.
When we catch wading in a river cathode cable we pull near
behind so that space out between electrodes must be not greater
than 2-3 metres.
Switching the device by pressing START should be no
longer than for 10 seconds. If the consumed current is lower than
10 A you can hold on the START button longer and in case of 5
A you can keep it very long.
To Next Page
Loading...