1
3
1 2
•
Put mixed silverware into the special basket with the handles facing downwards.
• Wash the dishes immediately after use, in order to prevent any residuals from hardening and sticking
on them.
• Load the rack into the machine and close the door.
• To avoid breakage, use only dishes that are intact and guaranteed for machine washing.
Do not place silver and stainless steel cutlery in the same basket, since this would cause the silver to
tarnish and the steel to corrode.
4.4 Cycle selection and start-up
• Based on the type of dishes and their conditions,
three types of cycles are available. (
Fig.4 ).
• Select the wash cycle that is suited for the dishes
to be washed. Repeatedly press the key
PROGRAMME SELECTION
key (2) to show the
selected cycle on the display.
• To start the programme, press the START button
(3) as shown alongside.
• During the cycle, the key turns blue (
Fig.5 ) and
the time bar shows the progress of the cycle.
• The cycle ends with two short beeps. The START key (3) of the selected programme returns to
green and the display shows the message ‘END’. The time bar flashes.
• A few seconds after start-up, it is possible to start the wash cycle in advance by pressing the START
key (3).
• In order to get rapid drying, immediately remove the rack from the machine at the end of the cycle.
• As indicated in Fig.5 led "A" means that for the next cycles, just close the hood and washing
starts automatically
• To de-activate this function, with the door open, press and hold the START key (3) for five seconds.
4.5 Turning off the machine
• Press the button ON/OFF (1). The machine will shut off. On the DISPLAY (4), the middle segments
will stay on to show that the machine is powered up. Then, always disconnect the main power supply
up the line from the machine.
4.6 Removal of integral filter
1. Turn off the machine.
2. Place the wash and rinse arms at a right angle to the edge of the door
(Fig.6 ).
3. Raise each semi-filter, grasping it by the handle.
To Next Page
Loading...
