With each wash cycle.
Compartment
For programmes with pre-wash only.
(Follow the user instructions!)
Electric indicator on control panel (if provided).
Check the rinse aid level
Load the baskets
Switch off the appliance
Turn off the water tap,
unload the baskets
Fill the detergent dispenser
Warning: wait a few m inutes (about 15 minutes) before unloading the dishwasher to avoid handli ng
the dishes and utensils while they are still hot and more susceptible to break.
They will also dry better.Unload the appliance, starting from the lower basket.
Scrape off any large amount of leftover food. Soften remnants of burnt food in pans,
then load the baskets. Refe r to the dishwasher loading instructions.
When the working cycle has finished, the buzzer of the
dishwasher will sound 8 times, then stop.
Turn off the appliance using the On/Off Button.
Switch on the appliance Press the On/Off button to s witch on the appliance, Open the door.
For d etailed operating method read the corresponding content on the instruction manual.
Select a programme
Turn o n the water tap and press the Start/Pause Button. The machine will start working
after about 10 seconds.
Running the dishwa sher
Changing the programme
Add forgotten dishes in the
dishwasher.
If the appliance is switched
off during a wash cycle.
O pen th e door carefu lly.
Hotsteam may escape
w hen the door i s open ed!
If the appliance is switched off during a wash cycle, when switched
on again, please re-select the washing cycle and operate the dishwasher
according to the original Power-on state ).
Close the door,press the Programme Button to select a desired programme.
( See th e section entitled Operati ng instruction )“”
1.PresstheStart/PauseButtontostopthewashing.
2.Open the door a little .
3 .Af ter the spray arms stop w orking, you can open the door completely.
4 .Add forgotten dishes.
5 .C l ose the door
6 .Press the Start/Pause Button, the dishwa sher will run after 10 seconds.
1 . A running cycle can only be modified if it has been running for a short time. Otherwise the detergent
m ay have already been released and the water already drained. If this is the case, the detergent
d ispenser must be refilled.
2. Press the Start/Pause button then press the program button for more than 3 seconds to cancel the
running programme.
3. Select a new programme.
4 . Restart the dishwasher .
To Next Page
Loading...