The following things should be checked before starting the dishwasher.
The content of this manual is very helpful to the u sers.
After installation, please make sure to keep this manual.
1
The dishwasher is level and fixed properly
2
T he i nlet va lv e i s o pen
3
There is a leakage at the connections of the conducts
4
The wires are tightly connected
5
The power is switched on
6
T he inl et and dr ain ho ses a re k notte d
7
All packing materials and printings should be taken out from the dishwasher
Extension Hose
If you needa drainhose extension, make sure to usea similar drain hose.
It must b e no lon ger t han 4 met res ; ot herwise the clean ing effect of the dishwasher coul d be reduced .
Wa t e r O u t l e t
Connect the wat er d rain h os e. The dr ain h ose mu st be correct ly fit ted t o av oid w ate r lea ks.
Ensur e t hat th ew ate r dra in hose i s no t kin ked or s quashed .
I f the si nk is 1000 h i gher from t he floor, t he ex c ess w a te r in ho se s ca nno t be drai ne d dir ec tl y
into the sink. Itwill be necessary todrain excess water from hoses into a bowlor suitable
containe r tha t is held outsi de and lower th ant he si nk.
How to Drain Excess Water From Hoses
Syphon Conn ection
Insert th e dr ain h ose into a d rain pipe with a m ini mum diamet er o f 40mm, or let it run into th e sin k, m aking su re t o
avoid be ndin g o r cr imping it. The top of the ho se must be les s t han 100 0mm.
To Next Page
Loading...