12
TurningontheAppliance
Premise:
1. A cycle that is underway can only be modified if it has only been running
for a short time. Otherwise, the detergent may have already been released,
and the appliance may have already drained the wash water. If this is the case,
the detergent dispenser must be refilled (see the section entitled " Loading the
Detergent " ).
2. Press current prog. Button more than 3 seconds to cancel the program ,
then you can change the program to the desired cycle setting (see the section
entitled " Starting a wash cycle. . . " ).
3. Press one of others prog. Button more than 3 seconds to cancel the runing program ,
translase the program which you press.
4. Press the display button more than 3 seconds to re-edit display time .
If display window shows error codes(page 25th), that indicates the machineisoutoforder,
please turn off the main power and water supply before calling a service.
NOTE:
Starting a cycle wash
4 Close the door, press the ON/OFF button, and the ON/OFF light will turn on.
Press the Progragram Button to select a desired Wash cycle,After 3 seconds,the machine will work.
1 Draw out the lower and upper basket, load the dishes and push them back.
It iscommended Thatloading the lower basket first, than the upper one (see
the section entitled "Loading the Dishwasher ).
2 Pour in the detergent (see the section e`ntitled Salt, Detergent and RinseAid ).
3 Insert the plug into the socket. The power supply is 220-240 VAC /50 HZ,
the specification of the socket is 12 A 250 VAC. Make sure that the water supply is
turned on to full pressure.
“”
”
To Next Page
Loading...
